You may notice that your fence is sagging or has gotten so dry that it is exposing your compound. The fence can break down completely without you noticing, if you are keen enough. The details of the fence can be the reason for the deterioration of the fence. If you are looking to replace your dilapidated fence, you should consider the following.
You are supposed to be conversant to the local zoning laws. There are some structures whose construction will require a permit from the authorities. You should determine whether a permit is required before you commence the construction, even if you are doing it on the old space. You may end up getting fined for doing a construction without the permits and legal documents. The new fence has to constructed in accordance to the set standards. You may as well get fined or asked to put the fence down if it doesn’t comply with the set guidelines. You should also check with your utility provider even if you intend to build the fence on the same spot. This will help you to identify the points where lines pass through, so that you don’t interfere with them during the construction.
The materials to be used in the construction of the new fence ought to be looked at as well. You should have in mind the duration you want the fence to last. Your budget also needs to be considered before you go out to buy the building materials. If you want a fence that will last for longer, you must purchase materials of a higher quality. These high quality wood materials will cost a lot more, but if the money is enough, you can entirely replace the wood materials with those made of aluminum vinyl. All the remains of the old fence must be removed from the site so that you can get the space to dig deeper for the posts. The materials required in the building of a sturdy fence ought to be very strong. And the foundation has to be firm as well.
Finally, you need to map out the layout of your new fence. The position of the posts and the corner points must be identified as well. Marking these points can be done using batters and strings because they are easily identifiable. Shovels and digging bars can then be used to dig the holes at the marked points. Power augers can be used to dig the holes if the compound is huge because you may end up spending a lot of energy and time to accomplish the digging. Once you are done digging the holes to the size accepted in the code, you should then set the posts and rails in that order.
More reading: more information